[Elecraft] [P3] P3 and K144XV

[Tom Azlin N4ZPT]

Hi Stan,

Adjusting the ref level does not help. Looking at the IF output of the 
P3 the actual signal level is not changing when I switch between 6m and 
2m. I hooked up my QS1R SDR and can see the signals fine when the P3 
water fall display is orange when I am on 2m. I can not find a ref level 
that works. Radio is working fine on 2m as I can copy signals fine.

When i disconnect the serial cable between the P3 and K3 the display is 
fine minus frequency and filter info of course.

All the software is up today. Both of my K3s do this.

Any ideas gang??

73, tom n4zpt

On 8/6/2011 11:13 AM, Stan Gibbs wrote:
> Tom,
>
> Sounds like your "Ref Lvl" is set too high.  The color of the waterfall
> reflects the vertical position of the trace in the frequency display.  If
> you reduce the reference level, the frequency display will return to a
> viewable position, and the orange waterfall will revert to blue.
>
> The reference level is per-band so you have to adjust it for each band you
> operate on.  For my 2m setup the ref level is set at -145 dBm, which allows
> me to see the frequency trace when the pre-amp is on or off.
>
>
>
> -----
> 73, Stan - KR7C
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/P3-P3-and-K144XV-tp5472582p6659797.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>