[Elecraft] Setting K3 Power Levels For KPA500

[GDanner]

My Got Ya:
One part of the learning curve that I discovered is that you must turn on 
the K3 before placing the KPA500 in Operate when you first power=up the 
station.
On my desk it was just more logical to turn on the KPA first and while I was 
there to press Oper. I Then had to figure out why I overdrove the power amp.
Once I overdrove the amp all was good since placing the amp in Operate again 
cured the original Operator Error!
George
AI4VZ

-----Original Message----- 
From: Bruce
Thank you Ron and everyone else.
I could not find that somehow, just tried it, including presetting the power 
levels, boy does work slick!