[Elecraft] KPA500 #181

[Geoffrey Downs]

The assembly manual says the resistance between the tab of U3 and the 
mounting screw or heat spreader is "typically greater than 5000 ohms", so 
it's not total isolation you're looking for, unlike the four rectifiers on 
the rectifier board. In my case the DMM read 10,000 ohms between the tab of 
U3 and the mounting screw and heat spreader, which I took to be ok. However, 
I've not finished assembling the KPA500 yet, so there could still be smoke 
when I finally switch on!

73 to all

Geoff
G3UCK

-----Original Message----- 
From: Peter Dent
Sent: Wednesday, August 03, 2011 6:49 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] KPA500 #181

My KPA500 went together well EXCEPT I could not get isolation between U3 and
the heat spreader but  I continued assembly any way.

Now when I switch on I get 0 HV message in the readout.

BTW the reason for the delay between assembly and this email is that the XYL
and I have just spent a week in VK3 land (Melbourne) Australia..

Any thoughts or suugestions?

Peter  ZL1PWD
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html