[Elecraft] RIT?

[Dave Perry N4QS]

Tommy,

I tried my RIT and I agree that the VFO A frequency appears to move as you 
turn the RIT knob.  But if you transmit, the VFO A frequency reverts back to 
the original frequency.  I suppose it might be better to keep the VFO A 
frequency the same and only show the offset +/- setting for RIT in the VFO B 
display.  That might be less confusing.  I never noticed the issue until you 
pointed it out.

Dave, N4QS

----- Original Message ----- 
From: "Tommy Alderman" <aldermant at windstream.net>
To: <elecraft at mailman.qth.net>
Sent: Thursday, September 30, 2010 6:36 PM
Subject: [Elecraft] RIT?


> I'm not sure how this is supposed to work and I can not find an answer in
> the K3 manual. When I first got my K3, I thought when I was tuning RIT 
> that
> my receiver frequency changed but the VFO A display did not. Now when I
> change RIT, VFO A frequency reading also changes and to me, this is
> indicating my tx frequency is being shifted also. I have CONFIG:VFO OFS 
> set
> to OFF and RIT CLR set to UNDO OFF. Can someone please tell me the 
> 'normal'
> operation of RIT?
> Thanks.
> Tom - W4BQF
>
>


--------------------------------------------------------------------------------


> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html