[Elecraft] KRX3

[Don Wilhelm]

  Mike,

Yes, you will have to set TECH MD to ON as indicated in the manual.  Set 
the VCO MD to CAL and SUB and exit the menu, the operation is 
automatic.  The values you see are the result of the calibration.
You may turn TECH MD off after you finish the calibrations.

73,
Don W3FPR

On 9/27/2010 9:45 AM, Mike Weir wrote:
> Good morning all,
> I have successfully installed the KRX3 in my K3 I now beginning the calibration procedures.  First it is the synthesizer, I entered CONFIG:VCO MD the only two parameters I can find are Nor 41 and RF 127. Any more rotation of the vfo knob changes the RF setting. I believe I am not able to find the CAL parameter as I have not set TECH MD to ON. But in rotating the VFO and changing some settings in either NOR or RF are these saved or does the rig have to be in TECH MD ON first? If they are saved does this mean I have to redo the synthesizer cal procedure for the K3 again?
> Mike
> VE3WDM
> http://ve3wdm.blogspot.com
>