[Elecraft] K2 mounting of LC and Control Boards

[Don Wilhelm]

  Ian,

One set of washers is needed as a spacer - so just do it the easy way - 
when you mount the standoffs onto whichever board they are mounted to 
first, put the washers between the board and the standoff.  When you put 
the second board on the other end of the standoffs, put the lockwasher 
under the screwhead.

Now when you remove the screws from the standoffs, always remove the 
screw with the washer under the head - it is a bear to align the washer 
between the standoff and the board if the standoff is mounted at the 
other end.

73,
Don W3FPR

On 9/26/2010 4:19 PM, Ian Liston-Smith wrote:
> My KAT2 errata dated 25 Feb 2010 shows the washers between the standoff and the board, but the text says put between the screw heads and the board. Normally I'd think it wasnt that important and the washers are just used as spacers, but in case the space is tight when putting it all together which is right, the text or the picture?
>
> Come to think of it, it must matter or there wouldn't be an errata to change it. Is it just that the diagram hasn't been changed to match the text?
>
> Thanks,
>
> Ian, G4JQT
>