[Elecraft] K3 Froze

[The Smiths]

Turn off the utility program.  Un plug the power from the P3, disconnect the RS232 cable from the P3 and place it in the K3 directly.  If that doesn't work, go to your Device manager in the control pannel.  Open ports, and reconfigure the Com Port your using to run at 38.4K baud rate.. That WILL work.  Hope this helps.
If you require further help let me know.
 
> From: wa6dkn at charter.net
> Date: Sat, 25 Sep 2010 15:46:29 -0700
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] K3 Froze
> 
> My K3 froze up while downloading in The K3 utility program. The LED shows "MCU LD" and the red TX light is blinking under the power switch. I can not turn the power off with the power switch. I have to turn off the power supply. The K3 utility program can not communicate with the K3 so I can't reinstall the firmware code, however the P3 utility program can connect. I have tried turning off the K3 and then turning it back on holding the "shift/lo" button to reset. That does not work. I did download the latest K3 utility program. 
> 
> Any suggestions? Thanks 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html