[Elecraft] FW: P3 MKR SOLVED

[Gary Ferdinand]

It is too embarrassing to tell.   Tnx for reading :)

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net [mailto:elecraft-
> bounces at mailman.qth.net] On Behalf Of Gary Ferdinand
> Sent: Thursday, September 23, 2010 12:33 PM
> To: Elecraft
> Subject: [Elecraft] P3 MKR off freq?
> 
> I'm sure this is "user error," but so far this user fails to figure it
> out.
> This started happening right around the time I loaded the current
> firmware
> into both the K3 and the P3.  When I tune or recall a memory in the K3,
> the
> P3 correctly displays the frequency and it appears to be centered
> within the
> brackets on the smallest scan.  However, when I use either marker and
> line
> it up with a signal off the current K3 frequency and tap select on the
> P3,
> the end result on the K3 is off about a KHz and this also shows up on
> the P3
> - ie the signal I thought I put the marker on is now showing up down
> from
> current frequency.
> 
> Any ideas?  Yes, I have calibrated the P3 according to the instructions
> on
> p19 of the manual, and the transceiver settings are unchanged and
> specify
> K3.
> 
> Thanks in advance.... Gary W2CS
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html