[Elecraft] P3 MKR off freq?

[Bill K9YEQ]

Check your shift frequency.  I had the same issue and it took me a bit to
figure it out.  Once the NORM button was held in, voila, fixed!  There are
other offsets I am sure which could also change the center freq, but my
solution is the simple easy one.

Bill
K9YEQ


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Gary Ferdinand
Sent: Thursday, September 23, 2010 11:33 AM
To: Elecraft
Subject: [Elecraft] P3 MKR off freq?

I'm sure this is "user error," but so far this user fails to figure it out.
This started happening right around the time I loaded the current firmware
into both the K3 and the P3.  When I tune or recall a memory in the K3, the
P3 correctly displays the frequency and it appears to be centered within the
brackets on the smallest scan.  However, when I use either marker and line
it up with a signal off the current K3 frequency and tap select on the P3,
the end result on the K3 is off about a KHz and this also shows up on the P3
- ie the signal I thought I put the marker on is now showing up down from
current frequency.

Any ideas?  Yes, I have calibrated the P3 according to the instructions on
p19 of the manual, and the transceiver settings are unchanged and specify
K3.

Thanks in advance.... Gary W2CS