[Elecraft] K2, KAT2‏ and P6

[Bob Nielsen]

P6 should be included with your KAT2 parts.  It is listed as RF-P6 in the KAT2 manual and gets installed in the AUX-RF location on the RF board of the K2.  It will look similar to the picture in this Digi-key data sheet:

http://parts.digikey.com/1/parts/351741-conn-header-2pos-156-vert-gold-26-61-4020.html

Bob, N7XY
.
On Sep 20, 2010, at 7:27 AM, Ian Liston-Smith wrote:

> 
> I'm slowly working my way through the assembly of my K2 (serial no. 6905) and got to page 74, "Other Option Component Installation (optional)" near the bottom of this page.
> 
> It says: "If you have the KAT2 (ATU) [which I have] ... install 2-pin connector P6. Use the option manual's instructions."
> 
> Well I've looked through the KAT2 manual for info about P6 but not found any reference. I did a "Find: P6" search on the KAT2 pdf manual: nothing.
> 
> So... what does this P6 look like and which way should it be installed? Presumably it's in the KAT2 bag of bits somewhere.
> 
> I must be overlooking something obvious, as a search in the list archive did not reveal anyone else asking this question.
> 
> Thanks and regards,
> 
> Ian, G4JQT  		 	   		  
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html