[Elecraft] K3 Crashed

[Ken Chandler]

Hi guys

I have it Fixed, it was a polling issue, clicked start, settings, control panel, system, hardware, device manager, click on ports, I'm using com8.... Open com8 by clicking, port settings, re-set bit per second (I set it to 38400) press ok.
I opened elecraft utility, k3 polled correctly, k3 detected the new firmware, clicked on 'send new firmware to k3' loaded correctly.
P3 firmware loaded correctly also.


Ken..G0ORH 

CW4EVER

Sent from my iPhone

     


On 19 Sep 2010, at 12:25, Rick Prather <k6limaecho at gmail.com> wrote:

> From the Owner's Manual:
> 
> Forcing a Firmware Download
> If you accidentally load an old or incompatible firmware version and find the K3 unresponsive, do the following: (1) unplug the K3 from the power supply and wait 5 seconds; (2) plug the power supply back in; (3) hold the K3’s    switch in; after about 10 seconds, you’ll see the TX LED flash (you’ll also see MCU LD on the LCD); (4) load the correct firmware version.
> 
> Worked for me..
> 
> GL,
> Rick
> K6LE
> 
> On 9/19/2010, at 4:20 , ken chandler wrote:
> 
>> Hi
>> 
>> Thought I would load up the latest beta firmware. Have had  no problems in
>> the past loading the beta.  However, after an on screen message turn p3 off
>> the k3 lock-up and have MCU LD on screen.
>> 
>> 
>> 
>> The k3 would not power down so I switched the supply  off!!!!!
>> 
>> 
>> 
>> Now I have the TX lamp flashing away and the radio trying to find a port
>> com8
>> 
>> 
>> 
>> Any suggestion please!!
>> 
>> 
>> 
>> Ken..G0ORH