[Elecraft] K2 - Need Some Help!

[stan levandowski]

Thank you to eveyone who responded so quickly.  Yes, I should have 
looked at the schematic but frankly it didn't occur to me as I was 
overly preoccupied trying to understand the instruction manual.

I don't want to make a big deal about this but if the instructions 
simply said to use the two outer holes and leave the middle hole empty, 
there would be nothing to misinterpret and it would be correct whether 
the builder was looking at the bottom of the board or the top; whether 
the builder was choosing to solder the top pads or the bottom.  At least 
that's the way I would have written it.

Thanks again everyone!  Now I have to go desolder...

Stan Levandowski WB2LQF
HF QRP CW -- Doing more with less for over 50 years!
QCWA #35038   OOTC #4558   NAQCC #4740   SKCC #6488   FISTS #(Pending)