[Elecraft] K3 - CONFIG question

[Tommy Alderman]

Poul-Erik,

To get N1MM Logger to key my K3, here are my settings that work:

K3: 	RS232 = 38400
	CONFIG:PTT-KEY = rts + dtr

N1MM	Config/Hardware
		Com 3: Elecraft K3 (in my case)
		CW/other  checked
SET:		38400/N/8/1
		DTR = CW
		RTS = Always OFF

This works and follows N1MM CW speed settings up to its max, plus VOX and
PTT still works. Of course if you have other software that you use, then you
have to reconfigure your K3 for that software.

73,
Tom - W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Poul Erik Karlshøj
(PKA)
Sent: Thursday, September 16, 2010 4:19 AM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 - CONFIG question

What are the correct settings of the K3 and of N1MM for keying (CW) the K3
from N1MM?
Sorry if this has been answered in the past - if so pse just a link.
Poul-Erik, OZ4UN