[Elecraft] FW: P3 and K3 RS-232 baud rates

[Tommy Alderman]

Same here Ed. I now know how to use my logging program at 4800b and then
N1MM Logger at 38400b. Very simple once you understand how it works.

73,
Tom - W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Cunningham
Sent: Tuesday, September 14, 2010 10:22 PM
To: w0yk at msn.com; elecraft at mailman.qth.net
Subject: Re: [Elecraft] FW: P3 and K3 RS-232 baud rates

Ed,
I think you are misunderstanding.  You would only have to change the 
configuration IF you needed to have P3 set to 4800 baud or some other rate 
than the default 38400.  I use P3 and K3 at default rates and have no 
problems at all, P3 on or off.
73,
Don, WB5HAK 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html