[Elecraft] K2: current documentation on remoting KPA100/KAT100?

[Don Wilhelm]

  John,

That guide is still good if you read the update notes.

However, if you are mounting both the KAT100 and the KPA100 both in the 
same EC2 enclosure it is much easier.
Order the KAT100-2, and you will find it has the 10 pin connector for 
the KPA100 control cable as well as the DC and antenna connectors - so 
all you need to do is plug the KPA100 to those connectors.  When you 
make up the control cable indicated in the KAT100 manual, that one cable 
is then sufficient to bring the K2 control signals to the KPA100 and 
KAT100 combo, plug it either into the KAT100 or the KPA100.  You will 
need a BNC to BNC cable between the K2 and the KAT100 AUX RF jack, and 
you will need a short PL259 to PL259 coax to connect from the KPA100 to 
KAT100 input.
The KIO2 or a suitable substitute is needed in the K2.

73,
Don W3FPR

On 9/13/2010 10:08 AM, John Shadle wrote:
> I know of this one link.
>
> http://www.kk7p.com/k2kpa100.html
>
> Is this the most current/best guide for remoting the KPA100/KAT100?
>
> Are there other guides which offer different/better information?
>
> Thanks.
> -john W4PAH
>