[Elecraft] CNC Heavy K2/K3 knobs

[Tony Morgan]

  Please, let's not do the knob thing again, been there, done that.
Check the archives.

73,

Tony W7GO

On 9/10/2010 8:33 PM, Richard S. Lindzen wrote:
> $150 plus heavy enough to bend shafts.  Wow.
>
> Dick, WO1I
>
> At 10:31 PM 9/10/2010, GEORGE CORTEZ wrote:
>> Found these on the net and thought some of you may like this
>> A bit on the pricey side
>>
>> http://www.73cnc.com/73cnc/elecraft.html
>>
>> George NE2I
>>
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>