[Elecraft] How much power does it take to drive ...

[Robert Friess]

The KPA500 requires 30 to 40 watts for full output.  With 10 watts of drive
the output will be around 200 watts or a little less.

Bob, N6CM



On Wed, Sep 8, 2010 at 8:15 PM, Phil Townsend <philji at mac.com> wrote:

> The KPA 500?
> Will I need to upgrade to the 100 watt machine or will the ten watt k3 do
> the job.
>
> Phil
> Santa Fe, NM
>
> Sent from my iPad
>
> On Sep 8, 2010, at 6:58 PM, Lyle Johnson <kk7p at wavecable.com> wrote:
>
> >  Yes, except the fan on the rear is a bit deeper than the twin fans on
> > the K3/100.
> >
> > 73,
> >
> > Lyle KK7P
> >
> >  Is the form factor for the yet to be available KPA500 the same as my K3?
> >
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>