[Elecraft] K3 & microKeyer 2 setup

[Bill Henderson]

Hi

Part 2

I'm very nearly there thanks to the help given so far.

(i) I managed to get through the "6 - Setting Audio Levels" to point 8 on
page 46. The next step, adjusting the Balance, has no effect on my ALC
levels. Am I right to assume that I can ignore this for the the K3?

I've done nothing about the DVK tab as I don't plan on using it just now.

(ii) I use Winwarbler in DXLabs for PSK and RTTY. I've set this up for FSK.
Should I be using the PSK D and FSK D settings on the K3?

(iii) When I run a macro (in Winwarbler) on FSK it puts the K3 into
transmit, sends the message and puts the K3 back into receive. However, when
on PSK the same macro is sent okay but at the end of the macro the
microKeyer 2 clicks but the K3 stays in transmit. What am I doing wrong?

Please help

Bill
GM0VIT
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-microKeyer-2-setup-tp5492196p5498117.html
Sent from the [K3] mailing list archive at Nabble.com.