[Elecraft] P3 Cursor Position Incorrect After Band change...

[Jim Cox]

I have noticed the cyan cursor has gotten out of sync on rare occasions, a 
mode change always corrected it.
I cant replicate your sequence of band change, mode change, etc.  It works 
fine here every time..

Jim k4JAF

----- Original Message ----- 
From: "Phil Hystad" <phystad at mac.com>
To: "Elecraft Reflector" <Elecraft at mailman.qth.net>
Sent: Thursday, September 02, 2010 5:48 PM
Subject: [Elecraft] P3 Cursor Position Incorrect After Band change...


> On my P3, I notice that the little cyan cursor location does not align 
> itself properly during a band change that also involves a mode change. 
> For example, switching from 17 Meter band with USB to 20 Meter band with 
> CW leaves the cursor aligned to the right of the center position as it 
> would be for USB but not as it should be for the CW signal.  All IF shift 
> controls are in their normal position.  Indeed, a power off and power on 
> cycle of the P3 resets the cursor location to be correct.
>
> I figure if a power-off/power-on fixes a problem then there probably is a 
> problem.
>
> Anyone else seen this same thing?  If it is unique to my P3 maybe I have a 
> very special P3 that might be worth a lot of money (sort of like an old 
> stamp with a flaw in it).
>
> 73, phil, K7PEH
> K3 #3799, P3 #0030
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html