[Elecraft] K3 & microKeyer 2 setup

[Bill Henderson]

Hi

Thanks for getting back to me so soon.

<<Have you set the jumpers in MK II for an electret mic? >>

I've connected
(i) the jumper to the 2 pin connecter in fron of the middle pot
(ii) the jumper on the two pins (EL) of three pins near to the EXT MIC
(iii) the jumper on the PA-RE-SS covers the two pins at the PA end
(iV  the jumper on the LNA-RE-SS covers the two pins ont the LNA end

 I have not connected
(i) the jumper onto the ICVOX pins
(ii)  the jumper on J11 near the power input. 

<<Have you set Router to select the rear mic ("Microphone 
Selector" on the Audio Switching tab)?>>

Yes

<<What adapter are you using between the ProSet K2 and 
the Foster to RJ-45 adapter connected to the rear of 
the MK II? >>

The one that was supplied with the rest of the cables - bought new from
microHam.


 <<Have you set the "EXT MIC" jumper for IC and tried using 
the EXT MIC (3.5mm) jack on the front of MK II? >>

<<Please refer to the user manual>>

I am.

I must be doing something wrong but I can't find it.

TIA

Bill




-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-microKeyer-2-setup-tp5492196p5492595.html
Sent from the [K3] mailing list archive at Nabble.com.