[Elecraft] [K3] Firmware load gone bad.

[Jim Cox]

See p 45 of the manual "Firmware Upgrades".

Jim K4JAF
----- Original Message ----- 
From: "Jens Petersen" <ov1a at c.dk>
To: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Thursday, September 02, 2010 11:41 AM
Subject: [Elecraft] [K3] Firmware load gone bad.


> Hi.
> 
> While attemting to load newest firmware the upload never started and
> display says "MCU LD" and TX is blinking.
> 
> Got newest K3 utility but there is no connection to K3.
> 
> K3 can now do nothing but blink the TX LED and display says MCU LD.
> 
> How do I reset K3 so I can try again?
> 
> K3# 3238
> P3# 310
> -- 
> OV1A Jens
> 
> Remember, If you're not in bed by 22:30..... go home!
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html