[Elecraft] New problem switching frequencies and modes with K3 FW 4.05

[Dave Perry N4QS]

Brian,

Your suggestion was right on the mark.  I must have accidently tapped option 
5 under CW Weight.  I now remember briefly looking at that setting when it 
was mentioned by someone last week on the reflector.  All I had to do was 
tap 5 to set it back to VFO NOR.  Thanks to everyone for your great 
responses.  I really appreciate it.

BTW, I received my P3 two days ago.  All I can say is that it is one nice 
piece of engineering.  Just another addition to the growing Elecraft legend! 
When can I order the KPA500?

Dave, N4QS

----- Original Message ----- 
From: "Brian Alsop" <alsopb at nc.rr.com>
Cc: "'Elecraft Reflector'" <elecraft at mailman.qth.net>
Sent: Wednesday, September 01, 2010 6:15 PM
Subject: Re: [Elecraft] New problem switching frequencies and modes with K3 
FW 4.05


>I believe this problem is caused by setting the CW WGHT option 5 to VFO
> OFS.  Try setting it to VFO NOR and see if the problem goes away.
>
> I seem to recall having had problems like you are now experiencing when
> this option was introduced many versions ago.
>
> 73 de Brian/K3KO
>
>
> Dave Perry N4QS wrote:
>> My K3 (SN 3132) has been working happily in sync with DX4WIN and N1MM for 
>> over a year now.  Normally, when I double click on a spot within the DX 
>> spot window of DX4WIN, the K3 immediately changes to the correct spot 
>> frequency and mode.  Same goes with N1MM.
>>
>> Just a few days ago I noticed that the K3 is not always changing to the 
>> correct frequency.  The problem appears to occur when a spot causes a 
>> change in both frequency and mode.  For example, if VFO A is set on 
>> 14.008.00 CW-R and I see a SSB spot for 14200.00, when I double click on 
>> the spot, the K3 changes to 14.199.42 instead of 14.200.00.  Then if I 
>> click on a spot to go back to 14.008.00 the K3 changes to 14.008.58.  In 
>> both instances I have to double click on the spot a second time to get it 
>> to change to the correct frequency.  Note that the difference is +/- 0.58 
>> kHz.  The problem also occurs when switching from SSB to RTTY.  It also 
>> seems to be occurring using both normal CW and CW-R.
>>
>> Last week I loaded the new 4.05 firmware.  I am now wondering is this is 
>> a problem with the firmware.  Or have I somehow changed a setting?  The 
>> K3 worked perfectly for over a year.  Something has changed.  Any help 
>> would be appreciated.
>>
>> Dave, N4QS
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>