[Elecraft] [K2] control board resistance test

[Don Wilhelm]

  Pippo,

Check to be certain Control Board RP4 is well soldered.  If so, I would 
believe all is well.  Your readings vary by less than 10% from typical, 
which is usually OK.  If your DMM is battery powered, you may want to 
check for a weak battery which can cause higher than actual resistance 
readings.

73,
Don W3FPR

On 10/26/2010 10:00 AM, Giuseppe Sorrentino wrote:
> Hy to all. Just performed the test as indicated on page 22 of the manual i have
> 2 values different from ranges indicated.
>
> U6 pin 29  indicated 70-90 k  i have 96,5 k
> U6 pin 30 indicated 70-90 k i have 96,7 k
>
> Is there anyone (i know he is out there ;D) who can tell me if they
> are unacceptable values and what to do to solve the problem?? All the other
> values are good as indicated on the manual.
>   IZ2NYY
> Giuseppe "Pippo" Sorrentino
> Milano ITALY
>