[Elecraft] [K2] J1 and J2 on control board.

[Giuseppe Sorrentino]

Hy to all! K2 6995 still on the road...i know i'm a turtle, but i like it that 
way! I've just finished the control board and still not placed the jumpers 
through J1 and J2 cause just today i received several options from elecraft and 
also the KDSP2. I know that J1 and J2 will be the locations for male pin headers 
to connect the dsp option and i also know that on page 22 of K2 manual is well 
written " J1 and J2 (bottom side. These two connectors are provided for an audio 
filter option (KAF2 or KDSP2). An audio filter should NOT be installed until the 
K2 has been completed and tested". Well....but i also understood that when i 
will be ready to install the KDSP2 i will have to desolder the jumpers on J1/J2 
in order to solder the male headers. Now i was thinking: "What about installing 
now the pin headears on J1 and J2 and place the jumpers on the back as usual 
together with the pins of headers???" Is it insane as opportunity or not so?? 
And if good...i can solder all the pins of the headers for the moment or just 
the ones necessary to place the jumpers???

Many thanks (hoping have been clear!!!)
 IZ2NYY
Giuseppe "Pippo" Sorrentino
Milano ITALY