[Elecraft] RF Gain Factory Defaults

[GM4KGK]

Malcolm
This issue has been resolved with the latest version of the K3 Utility
(1.3.10.11).
Your firmware is probably OK, but it will do no harm to re-load it before
you run the Calibration procedure.
73
Norman - GM4KGK


Malcolm Rothwell wrote:
> 
> Unfortunately when I opt for factory defaults and click on "Calibrate" I
> get the following error message : E0400E3 ERR DSE on the K3 display and on
> the K3 utility I see "DSP command response did not arrive". 
> 

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/RF-Gain-Factory-Defaults-tp5658229p5658320.html
Sent from the Elecraft mailing list archive at Nabble.com.