[Elecraft] K3/P3 - To watch own TX, what lines need to be disconnected?

[Stan Gibbs]

nr4c wrote:
> 
> 
> Since it can be useful, and the proceedure is documented, why not make  
> it a 'feature', not a 'work around'?  A relay in the P3 and some code  
> to configure a soft key, and maybe a modal to activate yes/no.
> 
> 

I think the feature is pretty much already there: When you want to monitor
your TX signal, just go into the Config menu and set the RS232 baud rate to
something other than 38400 (which the P3 expects).  Transmit, and voila!,
your signal is visible.  To turn the default behavior back on, just restore
the baud rate to 38400 and exit the Config menu. You could even assign a
menu command to a PF key to accomplish this.

Seems to work here.  Is there any problem with doing this?


-----
73, Stan - KR7C
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-P3-To-watch-own-TX-what-lines-need-to-be-disconnected-tp5648858p5652039.html
Sent from the [K3] mailing list archive at Nabble.com.