[Elecraft] Norm 1 <SAV> ?

[Tommy Alderman]

Sorry - I did not include all of the information in my prior email.

Hi John,

My K3 (s/n 4521) works correct, I think- hihi! I punch the I/II button for
I, then set DSP for the bandwidth I want saved, then hold 'NORM' (is that
what you mean by "SHIFT"?) until <SAV> appears, then rotate the knob to the
left. I then do the same procedure for a different bandwidth and store this
BW in II. Now to get to my saved bandwidths, I have to press 'I' or 'II' and
it works just fine. If I press the NORM button until <NORM> appears and
select either "I" or "II", the bandwidth does change, because I can hear the
difference plus I can see the filter switch from FL3 to FL2, however the
bandwidth display on the K3 does not change. The bandwidth's I was testing
with were 500hz and 250hz.
Thanks for the Q in the CWT!
73,
Tom-W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of John Huffman
Sent: Friday, October 15, 2010 5:44 AM
To: Elecraft List
Subject: [Elecraft] Norm 1 <SAV> ?

  I can't get the custom settings for NORM1 or NORM2 to save.

FW 4.012
I set the bandwidth where I want the custom setting to be for NORM1 
(800HZ), I hold the SHIFT knob until it says <-- SAV --> and then still 
holding rotate the knob to NORM 1.  I release the knob.  When I hold 
SHIFT for <-- NOR --> it's back at the default of 400hz.

Is this for my radio or all radios with this firmware?

73 de K1ESE
John
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html