[Elecraft] New Firmware Issues with K3

[ab2tc]

Hi,

This is interesting. I don't have this problem whether I have "VFO IND"
turned on or not (normally I always have it on but turned it off just to
test this. Now, I use an older version of HRD (4.1 build 2321) but I thought
the rig control part hadn't changed at all). Also just for the record, I
don't double click a DX spot, just a single click will do.

AB2TC - Knut


Alan Bloom wrote:
> 
> I finally got HRD set up on a computer connected to the Internet so I
> can connect to a DX cluster.  I was able to confirm the bug.
> 
> Turns out it has nothing to do with the P3 or the new K3 firmware.  It
> does it with no P3 connected and K3 version 04.12.  Probably older
> versions as well although I didn't try them.
> 
> The problem is that in HRD, when you double-click on a DX cluster spot
> that is in a different band, HRD sends an FA command to change the K3
> VFO A to the new band/frequency (which is fine) but then for some reason
> it sends an FB command to re-set the VFO B to the old band/frequency.
> That causes the K3 to do a band change back to the old band.
> 
> A work-around is to go into the K3 CONFIG menu and set VFO IND to YES.
> <snip>
> 

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K2-LSB-Modulation-issue-tp5621370p5637131.html
Sent from the [K2] mailing list archive at Nabble.com.