[Elecraft] K3 Beta Firmware Rev. 4.14: P3 A/B switching improvement

[Wayne Burdick]

K3 beta-test firmware revision 4.14 is now available. The most  
important change is to the behavior of the A/B and REV switches when  
the K3 is used with a P3. (See release notes below.) You'll also need  
to install revision 0.36 or later of P3 firmware, if you haven't  
already.

Please send any questions to k3support at elecraft.com. For instructions  
on how to load beta firmware, see:

      http://www.elecraft.com/K3/k3_software.htm

73,
Wayne
N6KR

* * *

MCU 4.14 / DSP 2.60 / FPF 1.13, 10-6-2010

* P3 UPDATED CORRECTLY ON K3 "A/B" SWITCH PRESS.

* P3 FUNCTIONS CORRECTLY AFTER "REV" SWITCH PRESS:
Previously, holding REV at the K3 would cause the P3 to stop
tracking K3 VFO movement. Note: At present, holding REV
does not result in any change in the P3 display. This will be
changed in a future revision of K3 firmware.

* BN REMOTE CONTROL COMMAND (BAND CHANGE):
This command now changes bands more quickly.