[Elecraft] K2 Resistor R9 Question

[Paul Agoglia]

I began assembly of our K2 this evening, so we are in the early stages.  The control board assembly calls  for several 1% resistors, and it calls for testing these resistors with an ohm meter.  Three of the four checked out well.  The fourth, R9, an 806k resistor, checked in at 435k on one  ohm meter and just over 520k ohms on a different ohm meter.  We opted not to solder it in until we hear whether it will still do the job or should we request a replacement, or is there another way to test it.

Thanks

WN2K
Paul