[Elecraft] RIT/XIT offset control moves vfo A in large steps?

[Dick Dievendorff]

See CONFIG: VFO OFS on page 62 of the current K3 Owner's manual. VFO OFS
turns it on and off, and CONFIG:VFO CRS sets the tuning rate  (per mode).

73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Rick Stealey
Sent: Wednesday, November 24, 2010 7:09 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] RIT/XIT offset control moves vfo A in large steps?


In the K3 Utility program, ver 1.3.11.5, if you hit Help, then K3 Utility
Help, and look in the Contents tab and then Help over the Web, and then
Frequently Asked Questions you get to a fantastic document telling all about
features of the K3.

I suspect some parts of this document is out-of-date and discusses features
that were changed or not implemented yet but I want to be sure because this
is a feature I 
would like to make use of.   It says, "When RIT and XIT are both off, the
offset 
control advances VFO A in large steps, defined by the operator on a per-mode
basis (e.g. 2.5 kHz for SSB, 5/9/10 kHz for AM, etc.)."  This doesn't work
on my rig.  Is there something I failed to set up to get this to work, or is
it not implemented yet?

Rick  K2XT
 		 	   		  
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html