[Elecraft] K3 ATU Question

[nr4c at widomaker.com]

Try going into the CONFIG: menu and locate with the VFO B knob, KAT3.   
Rotate the VFO A kjnob until the display says installed.  Now close  
the CONFIG menu and turn OFF the K3.  Turn the K3 back on, and you  
should have ATU function.

This is covered in the MANUAL in detail.  Remember, however, you MUST  
cycle the K3 power to make it appear.

...bc   nr4c



Quoting Bill K9YEQ <k9yeq at live.com>:

> If you press and hold the tune button it will cycle on and off.  Try holding
> it down once to enable it.
>
> Bill
> K9YEQ
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ed G
> Sent: Monday, November 22, 2010 5:16 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] K3 ATU Question
>
> Hi Folks,
>      Maybe I'm missing something very basic (or maybe still in a SS fog),
> but when I try to use my internal K3 antenna tuner, the display says "no
> ATU."  I can go into the config menu and set the tuner to AUTO, and I see
> "ATU" on the display, but when I go to actually use the tuner, I
> can't...display says no ATU.
>      I should say I ordered the K3 with the internal tuner, but until this
> point haven't tried to use it - I'm assuming it's actually installed ;)  I
> do have the second ANT 2 SO-239 on the rear.
> --Ed--
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>