[Elecraft] <k3> Failed firmware load, my fault

[Dick Dievendorff]

That should have worked too! I don't think the firmware load failure was
because you clicked the wrong Send button.  Were you moving to a higher
version #?  If so, it should have had the same end result.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of wp4cw
Sent: Tuesday, November 16, 2010 7:35 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] <k3> Failed firmware load, my fault

Hello Guys,
I accidentally hit the "Send All New Firmware to K3",   I should of sent
"All Firmware to K3"
My firmware failed.  Un plugged power, plugged power back in, restarted
Electraft Utility,  loaded firmware, and was back on the air. Ted WP4CW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html