[Elecraft] Fw: K3 Firmware Issue

[Glenn Haffly]

Disregard , Closing the K3 utility and powering down the K3 And then 
restarting both , All is well now.

Glenn
K5ZE
----- Original Message ----- 
From: "Glenn Haffly" <ghaffly at satx.rr.com>
To: <Elecraft at mailman.qth.net>
Sent: Tuesday, November 16, 2010 9:14 PM
Subject: [Elecraft] K3 Firmware Issue


> Good evening , While trying to load 4.22 I had a momentary loss of AC 
> power
> as new firmware was being loaded. Currently the front panel shows MCU LD 
> and
> the red TX LED is flashing. The K3 utility is attempting to communicate 
> but
> , The only thing happening is a scroll of the various bps connection 
> speeds.
> The box to send checked items and send all new firmware to K3 are both
> grayed out.  I unplugged the K3 for a minute , applied power and held the
> power switch in for 10 seconds with no change.
>
> I would appreciate help getting firmware reloaded.
>
> Thanks , Glenn
> K5ZE
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.449 / Virus Database: 271.1.1/3260 - Release Date: 11/16/10 
07:34:00