[Elecraft] K3 Firmware Issue

[James Sarte (K2QI)]

Turn K3 off, and close the K3 Utility.  Restart K3 then the utility and try
again.

73,
James K2QI

On Tue, Nov 16, 2010 at 10:14 PM, Glenn Haffly <ghaffly at satx.rr.com> wrote:

> Good evening , While trying to load 4.22 I had a momentary loss of AC power
> as new firmware was being loaded. Currently the front panel shows MCU LD
> and
> the red TX LED is flashing. The K3 utility is attempting to communicate but
> , The only thing happening is a scroll of the various bps connection
> speeds.
> The box to send checked items and send all new firmware to K3 are both
> grayed out.  I unplugged the K3 for a minute , applied power and held the
> power switch in for 10 seconds with no change.
>
> I would appreciate help getting firmware reloaded.
>
> Thanks , Glenn
> K5ZE
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 
73 de James K2QI
President UNARC/4U1UN