[Elecraft] KPA100 fan test

[Don Wilhelm]

  Mike,

Is the "underline" cursor under the "ON" in the PA ON menu?  It must be.
To set up to "Edit the menu parameter", you must hold the EDIT button, 
and the cursor will move to the right.  Once it is there, tap the 
DISPLAY button to cycle through the fan modes.

73,
Don W3FPR

On 11/14/2010 5:37 PM, Mike Weir wrote:
> I have checked out just fine up until the fan test on page 49 of the assembly manual. I set the power control to above 11 watts now to edit the PA menu I get to the point were the display on the k3 reads   PA    ON   If I tap the display button I am not getting to the fan setup menu. I know I am doing something wrong with button pushing or something but just not sure what. In the manual it tells me to "Edit the PA menu parameter" I seem to be tapping menu and then tapping display to get to the secondary menu but when I get to PA I just can't get to the fan control options to do the fan test.
> Mike VE3WDM
> http://ve3wdm.blogspot.com
>