[Elecraft] Still no tx or rx on new K3

Robert Redmon k5sm.bob at gmail.com
Sun Nov 14 14:43:06 EST 2010


Help! I am still stuck. My new K3 (just finished partial assembly to 
K3-10 stage) does not transmit or receive. I discovered this yesterday 
when I tried to do the TX gain calibration. It failed (due to 0 output). 
I think hooked an antenna to Ant 1 and found I had almost no receive 
either. I can receive very strong signals but they are very weak on the 
K3. The ATU is installed and enabled as is the transverter io board. I 
have not installed the 100w amp, the second rx, or the 2mtr xvtr yet.  
What might be causing this? I am really frustrated that my new radio is 
fighting me in this way.

-- 
73, Bob K5SM



More information about the Elecraft mailing list