[Elecraft] Firmware 4.17 anomaly

[Forrest Hudspeth]

I had contacted support at Elecraft a short while back about losing my right
channel of audio.  I was certain that I had only placed stereo 1/8 inch
plugs into my back panel speaker jack, but it did sound like I might have
somehow damaged an audio IC.  As my headphone jack on the back and front
panel still had 2 channels of audio, getting the audio board fixed was a low
priority.

About a week that, I discovered that my Config:Spkrs setting was set to 1.
After changing it back to 2, I had my missing right channel.  Okay.  That's
fine, I could have set it mistakenly.

Only... today I was using the rig and heard a relay click and the right
audio channel dropped out.  I check the Config setting and sure enough, it
was set back to 1.  This had happened a couple of times since the original
discovery where it was mysteriously set to 1 but this is the first time I
could blame it on the rig spontaneously changing it.

I have placed a few macros in my P3 with the P3 Utility but otherwise do not
use the macros in the K3 Utility and very seldom use the PF1 and PF2
buttons, which have macros in them.

Anybody else experience this or have a fix?

Forrest WA3FAE K3 #977, Firmware 4.17, P3 #439, Firmware 00.41