[Elecraft] KX1 problem

[Don Wilhelm]

  Pedro,

Do you have the KXB3080 (or KXB30) option installed?  If so, be certain 
the wires on the top of the option board have been flush cut and the 
square pads are in place.  If the transistors under that board are not 
down flat against the main board, they will not allow the KXB3080 board 
to be laid flat and may short to the top cover.

Also check the ground wires on the crystals.  If they are not soldered 
low on the crystal case, they can contact the battery holders and put 
pressure on the main board when the bottom cover is in place.

73,
Don W3FPR

On 11/9/2010 11:00 AM, Pedro Correia wrote:
> Hi,
>
> I have a problem with my KX1, I notice that if apply some minor force to the covers my audio level will vary. This sometimes appends if I tap the main knob. I did a full soldering rework and still no solution.
> Any ideas please.
>