[Elecraft] Day 1: Fried something already?

[Don Wilhelm]

  Owen,

You have the procedure correct.

Yes, the caution about lifting one lead of T4 was if you want to 
investigate the relay further.
Because of the ground at the secondary of T4, if the relay is set, you 
will see zero ohms between all the pins except for the coil - that 
should not surprise you.

73,
Don W3FPR



On 11/7/2010 3:06 PM, Owen B. Mehegan wrote:
> Hi Don -
>
> Many thanks for your help! L25 and L26 look totally clean so I'm not
> going to mess with them for the moment. I'll look into testing K12,
> though I probably won't get to it until tomorrow. Can you clarify what
> I should do to set up this test?
>
> 1. Tune the K2 to 40m
> 2. Power off
> 3. Check for continuity between pins 7-8 and 3-4 on K12.
>
> Are you saying I need to lift one of the leads on T4 before doing this
> test, or is that just a caution in the event that I see other anomalies?
>