[Elecraft] Firmware 4.18 APF adjustment using shift control

[Don Wilhelm]

  Guy,

Firmware 4.18 is still available at the Elecraft website - it was 4.17 
that has been pulled AFAIR.
Yes, 4.18 has some problems that have been identified on this reflector, 
but for those who are willing to work around those problems, I am 
certain the firmware folks at Elecraft would like to have feedback of 
any other problems discovered.

Those who wish to "play it safe" should definitely retreat to 4.14 
(install all the files), but for those who are a bit more adventuresome, 
try out the APF and the improved noise gate, etc. as long as you are 
willing to work around the limitations that have been identified so far.

I often use beta releases of software, and I do expect a few glitches 
when I do - I figure that is my "cost" for trying something new.  The 
good thing about Elecraft is that they do respond to identified problems 
in a timely manner (unlike some others).  Lyle will certainly be busy 
when he gets finished with his weekend!  Let's provide him with 
information on any other glitches that might show up.

73,
Don W3FPR

On 11/6/2010 6:58 PM, Guy Olinger K2AV wrote:
> Wayne has officially yanked 4.18. If SSB problems with 4.17, reload
> 4.14. Nothing until Lyle gets back.
>
> 4.17 alpha testers were going nuts on the APF and likely did little
> checking of the TX function change, which apparently had the SSB bug
> found in 4.17.  Any problems, reload 4.14.
>
> 73, Guy.
>