[Elecraft] K3 Utility Locking up

[Iain Kelly]

Good evening,

I've just started having a problem with the latest K3 Utility. When I 
run the utility without the rig turned on it tries to connect at each of 
the baud speeds as usual. If I turn the rig on (or indeed if the rig is 
already turned on when I launch the utility) the program finds the 
correct baud rate but then instantly locks up. The only way to exit s 
via the windows task manager.

Tried on multiple ports, multiple baud rates on K3 and USB adapter, 
nothing other than version of K3 utility changed since I last upgraded 
the firmware. Windows 7 64-bit happened with the previous version of the 
utility that was installed (hence downloading the new version).

I'm a little perplexed as the rig control works fine with the logger on 
the same serial port.

Any suggestions?

73, Iain M0PCB
(patiently awaiting my new KX1 kit to clear customs...)