[Elecraft] Adding options later for the K3

[Brett Howard]

2T Gen Kit?  I think he'd be better served with an XG1 or XG2...
Granted its nice being able to do an gain calibration however its not
required.

~Brett

On Tue, 2010-03-23 at 23:36 -0700, Fred Atchley wrote:
> Hi Mike. You might get things needed for building the K3 ahead of time, like
> a static pad/wrist strap, and a 50 Ohm dummy load. Get a good Phillip's Head
> screwdriver. I use a "Husky" 90044 #1. It has an 8" shank which helps reach
> areas where my fat fist won't fit. 
> 
> You'll need a signal source for calibration. If you're looking for an
> inexpensive signal source I suggest the Elecraft 2T-gen kit. This is an easy
> kit to build and it is perfect for use with the automated gain setup in the
> K3 Utility program.
> 
> I use the Heil footswitch and HM-10 mike so your Goldline should work just
> fine. Just set the Menu: Mic Sel to fPH (front panel, high) if you use the
> mike jack on the front of the K3 or rPH if you use the rear PTT and MIC
> jacks. 
> 
> The K3 kit itself does not require any soldering and the options are a snap.
> Just take your time and enjoy.
> 
> 73, Fred, AE6IC, K3 2241
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html