[Elecraft] New K144XV/KXV3A - problems on 2M - 1 milliwatt calibration ERR TXG and 'Unexpected response "DB 0.56 MW; " to "DB; " State 153'

[Brett Howard]

You look at page 69 in the Elecraft K3 Owners Manual

http://www.elecraft.com/manual/K3_Owner%27s_Manual_Rev_D6sm.pdf

~Brett

On Tue, 2010-03-23 at 17:12 -0600, david feldman wrote:
> Partially fixed - I had set XV1 ADR to TRN1 instead of INT TRN1.
> 
> Once I changed that, I found many problems corrected - I was able to set the two offset frequencies, I hear the relay switching between band segments, and I am now able to receive on 2M.
> 
> However, I repeated the calibration using the K3 utility and I still get this message:
> 
> 5 watt calibration succeeded
> IsSamplingComplete: Unexpected response "DB 0.52 MW;" to "DB;" State 153
> 1 milliwatt calibration failed
> 
> and after the calibration is done, I see the following on the display.
> 
> ERR TXG
> 
> How do I interpret this message?
> 
> I'm much closer now thanks to the quick help!
> 
> 73 Dave WB0GAZ wb0gaz at hotmail.com 		 	   		  
> _________________________________________________________________
> Hotmail: Trusted email with Microsoft’s powerful SPAM protection.
> http://clk.atdmt.com/GBL/go/210850552/direct/01/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html