[Elecraft] General Coverage Question - K3

[Brett Howard]

I've not got one in my radio but you should be able to hear it click in
as you tune well out beyond the edge of a ham band.  So maybe put it
into really coarse fast tune mode and head off the top end of the 80
meter band until you hear it click into place?  You could also pick a
frequency way between bands and turn the KBPF3 on/off and compare
amplitudes.  Keep in mind I believe that you have to power cycle the
radio after making changes to options that are installed. 

~Brett (KC7OTG)

On Sat, 2010-03-20 at 19:00 -0500, Don Cunningham wrote:
> Well, I have completed K3, s/n 4076 and all checks well at the low power 
> level with one exception.  I can't figure out how to put the K3 into 
> "general coverage" mode so I can see if the KBPF3 is recognized and working. 
> All else I have found, which in itself is amazing to me, hi.  I want to 
> check the KBPF3, then install the 100w amp while I'm on a roll!!!  By the 
> way, the W2 was a fun build, and works like a champ too!!
> 73,
> Don, WB5HAK 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html