[Elecraft] K2 and Digi Modes

[Doug Faunt N6TQS +1-510-655-8604]

I actually used miniature caps and have them standing up.  It installs
behind the front panel on a small standoff very nicely, with the pot
accessible from the top with only the cover off, so the level can be
adjusted using a signal through the radio.
I think I got the boards from Tom, but it's been a while.

And all that I have are committed now.

73, doug

   X_CMAE_Category: 0,0 Undefined,Undefined
   Date: Sat, 20 Mar 2010 13:13:01 -0400
   From: Don Wilhelm <w3fpr at embarqmail.com>

   Doug,

   You might want to mention which version of the fixed audio board you 
   have.  The original one had the electrolytic capacitors standing up on 
   the board, and the instructions for that board are on my website 
   www.w3fpr.com.  The later board had the components laying down and would 
   fit between the front panel and control board.  For instructions on that 
   board, look at www.n0ss.net.
   To give credit where it is due - Tom Hammond did the board layout for 
   both boards.  I sold the first version, and Tom sold the 2nd version boards.

   73,
   Don W3FPR

   Doug Faunt N6TQS +1-510-655-8604 wrote:
   > I still have 5 of the boards for the W3FPR Fixed Audio Output,
   > one of which is fully populated and tested.
   >
   > I had EA3BLQ's digital interfaces in both my K2's, but connector space
   > on the back panel got to be a hassle, and they were no longer
   > available.  So I went with the W3FPR version, which could be (and was)
   > installed in a K2 in DXpedition conditions.  But I ended up with
   > extras, so....
   >
   > I don't recall what I paid for them, but I'll send the populated one
   > to Rudi for postage, and one of the blank boards to anyone else for a
   > SASE to my callbook address.
   >