[Elecraft] K1 component damage angst

[egernet at hushmail.com]

Dear Bill,

Thanks a lot for the advice. I am much happier now.

> don't worry about the cap, the covering will often crack and even
> break off as you straighten the leads or 'stuff' it on  the
board.   

Good to know that there is no reason to worry. I will take your
advice as write down my observations for future reference

> Also, unless you were scuffling around on a wool carpet with silk
> socks just before you picked up the transistor, very doubtful you
> did any damage.

That's good to know. I touched the metal frame of the (wooden) desk
I was working at, and picked the MOSFET up by the black foam.

> they want to ensure clearance above Q2.

I was afraid that it was a very high gain transistor but looking at
the spec sheet, it is a 10 ns switch time part. Following your
suggestion, I will remove the part bend the leads and install it
again.

>HAVE FUN!!!

Hey, thanks Bill!

This was a (rather expensive) gift from my girlfriend and I am
enjoying every bit of it.


73, Chris