[Elecraft] ERR TXF

[Mike]

Jorge -

Do you mean you do not have either the 2.7 or 2.8 filter?

As Don and Joe said, you MUST have either the 2.7 or 2.8 filter to 
transmit in CW, SSB. or Data.

Here's a screen shot of the K3 Utility crystal filter setup for my rig. 
I have 2.8, 400, and 250 filters
http://nf4l.com/K3filt.htm

73, Mike NF4L

Jorge Diez - CX6VM wrote:
> At this point i really have a mess!...
>
> How I can configure filters?
>
> I have 400 hz and 1.8 khz in the main and the same filters in the sub RX
>
> Thanks in advance!
>
> 73,
> Jorge
> CX6VM
>
> -----Mensaje original-----
> De: K4ia [mailto:k4ia at aol.com] 
> Enviado el: Sábado, 06 de Marzo de 2010 09:19 p.m.
> Para: Jorge Diez - CX6VM
> Asunto: Re: [Elecraft] ERR TXF
>
> Did you set the transmit filters?
>
> Craig Buck
>
> On Mar 6, 2010, at 6:14 PM, "Jorge Diez - CX6VM" <cx6vm.jorge at adinet.com.uy 
>  > wrote:
>
>   
>> Hello,
>>
>>
>>
>> I have a ERR TXF message in the display of the K3 when I hold TUNE  
>> or when I
>> press XMIT.
>>
>>
>>
>> Also I cannot do the calibrate transmitter gain in the utility  
>> software
>> because of this TXF
>>
>>
>>
>> Any idea whats wrong?
>>
>>
>>
>> Thanks,
>>
>> Jorge
>>
>> CX6VM/CW5W
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>     
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html