[Elecraft] PA No worky...

[Ian Maude]

You should have the menu entry set to PA Nor.

73 Ian

-- 
Ian J Maude, G0VGS
SysOp GB7MBC & HB9DRV-9 DX Clusters
Member RSGB, GQRP 9838, FISTS 14077 | K3 #455
http://www.amateurradiotraining.org


On 26 June 2010 09:11, Brett Howard <brett at livecomputers.com> wrote:

> Ok well I'll provide a bit more information.  I've pulled the PA and
> taken a look at things and nothing looks like its gotten hot at all.
> Nothing is obviously wrong at all.
>
> I've checked all my filter settings (which hadn't changed since it was
> working a few minutes ago) and they all still seem to be correct.  I
> reloaded the firmware to the radio and also restored my previous
> configuration.  I've redone the synthesizer configuration because I've
> recently added the synth stiffeners.  I then redid the TXG
> calibration.  5 Watt TXG calibration goes 100% successfully.  However
> 100W TXG Calibration results in an ERR TXG message.  It seems like its
> doing everything that it should to make the radio produce 100 watts
> but the PA just isn't doing its job.  Flipping between PAio ON and
> PAio TST does produce a relay click so the PAIO is doing its job.  I
> should also mention that all fan speed tests check out ok as well.
>
> If I'm forgetting anything else to check please enlighten me.
>
> Thanks much gentlemen
>
> ~Brett (N7MG)
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>