[Elecraft] [K3] QRQ/CW+ and split

[GW0ETF]

=================================================================================
Note 1: There are limitations to QRQ CW mode at present. You cannot use
SHIFT, or turn on RIT, XIT, or SPLIT. However, you can still use splits, in
effect, if you have the sub receiver installed: Turn the SUB on, and use VFO
B as the receive VFO. (In a subsequent firmware release, RIT/XIT will be
usable over a small range in QRQ mode.)
=================================================================================

Is the plan to eventually implement normal split with CW+....?

To use SO2V in N1MM with the K3 requires using normal SPLIT. It would be a
pity not to be able to take advantage of the greatly improved keying with
CW+ at the higher speeds used in contesting.  

73,

Stewart Rolfe, GW0ETF
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-QRQ-CW-and-split-tp5216679p5216679.html
Sent from the Elecraft mailing list archive at Nabble.com.